If you are just visiting and found the information you were looking for please contribute to the running costs by making a donation.	Forums : : Register : : Log In : : Log Out : : Help : : Calendar : : Search
	My Setup : : Member List : : Contact Admin : : Today's Posts

All Forums >> [Bottle Forums] >> Cleaning and Repairing >> removing inside pry marks

Page: [1]

Login Message << Older Topic   Newer Topic >>

removing inside pry marks - 8/2/2006 12:42:35 AM    stinger haut   Posts: 518 Joined: 6/7/2006 Status: offline I tumbled a Buffum's soda with the inverted lip. It turned out near mint to my surprise. However, there are deep pry marks that were dicovered when the bottle was finished tumbling. They are all on the inside of the neck area. I can't reach them by hand because the neck is smaller at the top then flares outward. I could cut with 600 grit but I have a nice unpopped big bubble below the pry marks that would definitely burst with any cutting oxide. Any ideas on how to shield below the bubble and cut with the cutting oxide? Post #: 1

RE: removing inside pry marks - 8/3/2006 2:55:00 PM    Bottle tumbler   Posts: 370 Joined: 4/5/2004 From: Noxen pa Status: offline i would use an open tumble on this one. wayne has a stopple for this. then the copper can go right through the mouth instead of being stopped by the cone stopple, i would use 1200 and then poilsh. rick (in reply to stinger haut) Post #: 2

All Forums >> [Bottle Forums] >> Cleaning and Repairing >> removing inside pry marks

Page: [1]

New Messages No New Messages Hot Topic w/ New Messages Hot Topic w/o New Messages Locked w/ New Messages Locked w/o New Messages

Post New Thread  Reply to Message  Post New Poll  Submit Vote  Delete My Own Post  Delete My Own Thread  Rate Posts