If you are just visiting and found the information you were looking for please contribute to the running costs by making a donation.	Forums : : Register : : Log In : : Log Out : : Help : : Calendar : : Search
	My Setup : : Member List : : Contact Admin : : Today's Posts

All Forums >> [Bottle Forums] >> Cleaning and Repairing >> removing pry marks

Page: [1]

Login Message << Older Topic   Newer Topic >>

removing pry marks - 6/10/2006 11:03:02 PM    stinger haut   Posts: 518 Joined: 6/7/2006 Status: offline Anyone out there have any ideas on removing pry marks that are inside the neck on soda bottles? Running 600 cutting oxide is out because of bubbles in the bottle that would burst. Post #: 1

RE: removing pry marks - 6/10/2006 11:32:58 PM    welddigger   Posts: 552 Joined: 4/24/2004 From: Hereford,PA. Status: offline depends how deep they are and where there at but try buffing with a dremel and buffing wheel and compound also starting with 800 grit wet sand paper and working up to 1200 grit has work for me on liter scratches on the tops on bottles.it takes alot of elbow grease and i would first practice on a junker until you have a technique down,thats what i usually do on any kind if cleaning that could possibally leave serious damage!i would post pics but i have no before shots so when i get a bottle that needs work from now on i'll take before and after shots. (in reply to stinger haut) Post #: 2

All Forums >> [Bottle Forums] >> Cleaning and Repairing >> removing pry marks

Page: [1]

New Messages No New Messages Hot Topic w/ New Messages Hot Topic w/o New Messages Locked w/ New Messages Locked w/o New Messages

Post New Thread  Reply to Message  Post New Poll  Submit Vote  Delete My Own Post  Delete My Own Thread  Rate Posts