ROBBYBOBBY64
Well-Known Member
I have come up with a solution for cleaning the inside of a bottle of almost everything but sickness. I will try to make this as easy as possible.
Step 1- get copper scouring pads
Step 2-unroll pad until you get down to a roll 4 layers thick.
Step 3-cut the ring of copper pad in one spot.
Step 4-unroll one end and then tightly roll up around a wooden dowel and twist in any direction until it tightens up 3 inches on the dowel. (i am using a 1/4 inch dowel 12 inches long)
Step 5- I CA (Crazy glue) onto the stick.
Step 6- twist the copper into a tight whip like tail i bend over the end and twist in the same direction i twisted the copper onto the dowel. It should look like this picture.
Step 7- after it dries i put it in my electric hand drill tighten up the chuck. A little clr in the bottle, then i push the copper tail in the bottle. Turn on the drill and let her rip.
Step 8-Caution it foams the clr and expands so only use 1 or 2 inches in the bottle. Wait for drill to stop before removing from the bottle. The tail is sharp and will cut you. It works great for me. It never got twisted up and could not come back out. I go in both directions pulling in and out like a butter churn. Be safe use goggles.
Step 1- get copper scouring pads
Step 2-unroll pad until you get down to a roll 4 layers thick.
Step 3-cut the ring of copper pad in one spot.
Step 4-unroll one end and then tightly roll up around a wooden dowel and twist in any direction until it tightens up 3 inches on the dowel. (i am using a 1/4 inch dowel 12 inches long)
Step 5- I CA (Crazy glue) onto the stick.
Step 6- twist the copper into a tight whip like tail i bend over the end and twist in the same direction i twisted the copper onto the dowel. It should look like this picture.
Step 7- after it dries i put it in my electric hand drill tighten up the chuck. A little clr in the bottle, then i push the copper tail in the bottle. Turn on the drill and let her rip.
Step 8-Caution it foams the clr and expands so only use 1 or 2 inches in the bottle. Wait for drill to stop before removing from the bottle. The tail is sharp and will cut you. It works great for me. It never got twisted up and could not come back out. I go in both directions pulling in and out like a butter churn. Be safe use goggles.